Started and test drove vehicle. Could not duplicate the issue, put truck on lift to inspect for issues that could cause intermittent problems with steering and brakes, none found. At this time the truck is operating as designed.
Juston H. gave our service a 5 star review on 1/11/2024
Rotated tires, Left front had a leak, patched the leak and tire holds air well now. WHile tries were off, checked brakes, all pads at about 30% life remaining. Fuel filler light is from a leak in the fuel filler neck, would need to replace to fix the issue. Also has a bad tire pressure sensor in the right rear tire.
Elaine B. gave our service a 5 star review on 10/27/2023
Customer concern: Replace front missing hub cap. Install rear hub cap and straighten right rear tire valve stem. Estimate for body repair: Replace running board. Steering wheel is not straight.
Includes: inspect steering and suspension for wear adjust tire pressure check caster, camber and toe-in adjust toe-in as needed-was way off, adjusted and centered steering wheel
Includes: change engine oil & filter inspect and top off chassis fluids check and adjust tire pressure test coolant freeze protection ( -32 )
Pat E. gave our service a 5 star review on 7/26/2023
A/C compressor is locked up, needs new compressor and belt. Exhaust flex pipe is leaking, needs new flex pipe and catalytic converter. Customer declines repairs at this time.
Service air conditioner. Check condition of all belts and lines. Evacuate and recharge system. Inspect for leaks. Test system performance. Found A/C Compressor failed and needs replaced, belt is dry rotten and cracked.
Change engine oil & filter Lubricate Chassis as needed Check & top off fluid levels Test coolant freeze protection ( – 30 F) Check & adjust tire pressure ( 32 psi) Reset oil change light(if applicable)
Replace front brake pad linings. Check front brake disc rotor condition. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. Road test vehicle.
Karen W. gave our service a 5 star review on 6/15/2023
Dis-assemble and prep front bumper, rear bumper and driver side. Paint and polish same. Re-assemble and prep for delivery. Repair engine under tray. Dis-assemble door cards and repair woven fabric inserts. Re-stretched fabric and applied new adhesive.
Robert K. gave our service a 5 star review on 5/13/2023
Wiring harness has several bad spots, especially across valley at sensor connectors. Tab locks have been broken off at injector module. Repair wiring to get correct readings from sensors.
Perform several tests and found high pressure oil too low for engine to start (only getting about 350 max, needs 600 to start) perform leak test, fail. Found injection pressure regulator failed. Replace IPR and pigtail.
During wiring repair, found pieces of the intake manifold gasket broken off and laying in the engine valley.EGR cooler hose leaking as well. Replaced with intake manifold set.
Tony L. gave our service a 5 star review on 2/8/2023